Page 1 of 1

Thermostat housing

Posted: Fri Nov 01, 2013 7:37 pm
by nzchevy
I have a 1962 MKII Super Minx convertible. I have removed the thermostat housing and the bottom right hand corner is broken off. I have been offered a replacement but it is slightly different. Upon checking the parts manual my housing is an early one,part number 1218587 and the replacement I have been offered is a later one, part number 1214647, which is for the MKIII onwards. Apart from the position of the thermostat they look as though they should be interchangeable but does anyone know if they definitely are?

Thanks

Roger

Re: Thermostat housing

Posted: Sat Nov 02, 2013 2:35 pm
by rhythmrider
From what I have seen, you should have no trouble.
As a matter of fact I believe you can even use one from a Sunbeam alpine that is very different. (but you would need a different top, and bypass hose.)
You would need the thermostat cover that goes with it too to make the hose come out in the right place. Oh, I almost forgot, to use the Alpine type, you would need to replace the top two studs with long bolts.

Or if you want one that is exactly the same, get one for a "standard" Minx. It might be easier to find as a "Minx" part.

First pic is Alpine type, second is the original type.

Re: Thermostat housing

Posted: Sat Nov 02, 2013 6:44 pm
by nzchevy
The 'Alpine' one is the type fitted to the MKIII onwards, part number 1214647 and I think the 'Minx' type is part number 1218587. (I tried to load some pictures in my original post but the file size was too large?).

Speedy Spares only list the later type for both Minx and Super Minx so I'm guessing the early ones are scarce.

Thanks

Roger

Re: Thermostat housing

Posted: Sun Nov 03, 2013 4:00 pm
by rhythmrider
If you are not in a hurry, and want the original, they do come up on ebay.
But the ones that are there right now are way too expensive.

http://www.ebay.co.uk/itm/Hillman-Minx- ... 0897115607

Or you can get someone to do some soldering with some HTs-2000 (or similar) brazing rods to fix your broken one.
It would work very well for this application.

Also, if you only looked online at SpeedySpares, call them. They sometimes have items not on the list.

Good luck,
Dana

Re: Thermostat housing

Posted: Fri Nov 15, 2013 6:11 am
by rhythmrider
BTW, there is someone making reproductions for the newer type.
Looks to be poor quality very porous casting.
Might be worth seeing one before buying or make sure they allow returns if buying online.