Page 1 of 1

Door Mount Screw Suppliers ??

Posted: Fri Dec 28, 2007 11:46 pm
by scoot
Managed to get my rear door mounting screws (large philips head countersunk) out, but damaged a couple of the heads on removal. Anyone know of suppliers of new screws or the thread size so I could perhaps look at alternative suppliers ?

Posted: Sat Dec 29, 2007 6:30 pm
by BeJay
Hi Scoot,
.........if you take one of the old screws into any local nut & bolt/fasteners suppliers they should be able to check te thread and supply you with some new screws, you'll be better off getting new countersunk screws with the allen key heads though as they'll be easier to undo should you ever need to get them out again, if you don't have/know any local suppliers as a last resort you could send me one of the old screws in the post and I'll check with one of the local suppliers in Peterborough.
.............regarding your trim question, the narrow strips along the door tops and the rear wing and around the rearlights come off the same as the wide bits, (they're on smaller clips) they're just a bit more fiddly to do, just make sure you go carefully and "feel" your way along trying to get as near to the clip as you can before trying to prise it off, the trim on top of the wing going round the rear window (three sections if you look closely) just grips the seam underneath and just needs easing off carefully working your way along it, except the small quadrant sections at the very ends, these are held on by small nuts (approx 6mm) you'll be able to feel them from inside the boot, hope this is of some help.

......................cheers, Jack.

Posted: Tue Jan 01, 2008 6:59 pm
by sceptre511
HI
The screws are 5/16 unf thread. :)

Posted: Tue Jan 01, 2008 7:05 pm
by sceptre511
Should have mentioned,cut off the silly rivet that holds on the check strap and then you can get at the screws better,and replace the rivets with clevise pins and a small split pin.(available from car,hardware and boat shops ).

Posted: Tue Jan 01, 2008 7:59 pm
by archie001
I find these people are good for nuts and bolts.

http://www.namrick.co.uk

Posted: Fri Jan 04, 2008 4:59 pm
by scoot
Managed to get stainless replacement countersunk screws with allen key head for £5.00 including P&P thru ebay.....thanks for all the advice though

Re: Door Mount Screw Suppliers ??

Posted: Tue Feb 12, 2008 10:24 pm
by rootesmadnick
Alpine west midlands list originals in their latest catalogue as well !