Page 1 of 1

Hillman Super Minx

Posted: Mon Feb 08, 2010 5:17 pm
by dave B
Hi Guys, Please accept my appologies for using this site, but the Hillman owners do not seem to use the dedicated site, so I am asking if you guys can help? I am looking for a complete air cleaner assembly to fit the Zenith 34 1V carburettor, can anyone help, I am sure this carb was not fitted as standard to the Vogue & Sceptre but any thing is worth a try! Thanks for reading, I can be contacted on bullen.d@btinternet.com

Re: Hillman Super Minx

Posted: Tue Feb 09, 2010 9:00 pm
by Gary Knight
Hi, Dave, Although I can't help you with the air cleaner I can tell you that my Sceptre MK1 has twin Zeniths fitted to it as standard. The Sceptre had several different makes of carb during it's production run. A single twin choke Solex, and I believe Weber carbs were also fitted to the Sceptre. Is the air cleaner a kind of saucepan shape? Perhaps you can find an after market one in one of the classic car mag's classifieds or even try someone like speedy spares or Alpine west midlands, they might be able to help or at least point you in the right direction.
Sorry I can't be any more help.
All the best , Gary.

Re: Hillman Super Minx

Posted: Wed Feb 10, 2010 3:39 pm
by dave B
Hi Gary, Thanks for your thoughts, I have done most of the regular suppliers, but a subsequent conversation with another Vogue man,he has suggested that I am only missing the rubber sleeve that fits between the air cleaner and the carb, but as you say, so many different types of air cleaners and carbs have been used over the years. Still on a plus point it makes rummaging at Auto Jumbles worth while, Best regards Dave B.

Re: Hillman Super Minx

Posted: Wed Feb 10, 2010 10:53 pm
by Gary Knight
Hi, Dave thanks for the reply. If it's just the rubber seal you are missing you can fabricate your own which work reasonably well. I made some for my car from the kind of rubber strip you can get for boot/door seals, just cut to length push onto the air cleaner put on a large jubilee clip, push the air cleaner over the carb , tighten the screw on the clip and it should work! Hope this helps.
Regards, Gary. :)