Page 1 of 1
question about nuts and bolts.
Posted: Sun Nov 05, 2006 8:00 pm
by t148ljn
Can anyone out there advise me as to which imperial thread type was used on the series 1 humber sceptre as i need to purchase loads of nuts and bolts to assemble the car which I recently aquired. sorry to keep asking all these questions but I dont know who else to ask. Regards Paul.
Posted: Thu Nov 09, 2006 9:26 pm
by robbo
Phone Speedy Spares there quite helpful.
NUT & BOLTS THREADS
Posted: Thu Nov 09, 2006 9:29 pm
by RAYREES
HI PAUL,
THE THREAD USED ON YOUR SCEPTRE ARE U.N.F ,ALL ARE OBTAINABLE
BUT SOME COMPONENTS ON YOUR CAR HAVE 7/16 U.N.F NOT MANY
PEOPLE STOCK THIS , BUT IF YOU HAVE ANY PROBLEMS GETTING
HOLD OF ANY GIVE ME A RING AND I WILL SEND YOU SOME DOWN
ALL THE BEST
RAY
Posted: Fri Dec 01, 2006 7:22 pm
by t148ljn
many thanks for taking time to reply it really is appreciated. just wondering if you would know which way round the rubber seals on the master cylinder ( brake) face or where I could purchase a haynes manual for a series 1 humber sceptre. once again thankyou. Regards Paul.
Master cylinder seals
Posted: Sat Mar 10, 2007 12:08 pm
by Dave