Page 1 of 1

Petrol gauge misreading

Posted: Sun Mar 11, 2012 4:54 pm
by rusty nuts
Ages back i tried to fix this problem of not having the correct reading on the dial. I put another sender in the tank and also changed the dial.
I'm sure i even changed that small metal voltage regulator. Can the regulator be checked using a multi meter?

It says in the book that that mean voltage between the "I" and earth should be 10 volts. Do i set the meter at ten volts and put the multi meter wires on the regulator and see if it reads 10 volts.

Re: Petrol gauge misreading

Posted: Wed Mar 14, 2012 9:51 pm
by thowman
The voltage regulator opens and closes very rapidly, so it's very difficult to read correctly on a multimeter. You're better of getting a modern electronic type voltage regulator. You can get them from maplins and wire them into the existing casing, and they give out a steady 10v. Much better than the original.

http://home.mindspring.com/~purlawson/f ... ilizer.pdf

Have a read of this.

Andy

Re: Petrol gauge misreading

Posted: Thu Mar 15, 2012 8:12 pm
by rusty nuts
Thanks Andy.

Re: Petrol gauge misreading

Posted: Sat Apr 07, 2012 7:00 pm
by rusty nuts
I've got one of those Solid State Circuits off ebay but it doesn't have 1 2 3 marked on it like in the link. At a guess if i copy how its laid out in the diagram with the earth in the middle ??