Page 1 of 1
Unhappy starter
Posted: Tue Jan 23, 2007 7:53 pm
by big_steve
I have the 1725cc engine with a twin choke Solex carb. It hates starting from cold and is actually harder to start with the choke. Once ive got it running i have to sit in the car holding the revs at 1500 - 2000 until the engine warms enough to tick over. Its very lumpy until it warms to full temperature. Then the tickover sits at 1500rpm. I have tried to adjust the slow running in accordance to the handbook but a (fairly) smooth tickover when warm means a pig to start when cold. Cap, condenser and points are new. Plugs are set correctly. Car is very thirsty, could this be worn jets? If so, where can i source a set? (She runs perfectly when warm, its just the tickover is high)
Any ideas??? Cheers.
CARB TROUBLE
Posted: Wed Jan 24, 2007 9:18 pm
by RAYREES
HI BIG STEVE ,THE PROBLEM LIES IN YOUR CARB ,PUT IT IN THE BIN AND FIT A WEBBER CARB ,THE ONE YOU HAVE FITTED TO YOUR CAR WERE NEVER ANY GOOD EVEN WHEN THEY WAS NEW.
IF YOU REQUIRE A CARB CONVERSION FOR YOUR CAR PLEASE GIVE ME A RING AS I AM SURE WE HAVE A COUPLE LEFT.
ALL THE BEST RAY
TEL 07932 339503
Posted: Wed Jan 24, 2007 11:40 pm
by big_steve
Hi Ray.
Is there nothing i can do with the original carb at all? If i have to get a Weber then so be it, but id like to keep the engine original if possible. I noticed today that she runs better without the air filter, but the filter itself is clean and fairly new. Tomorrow im going to re-check the timing and re-check the points gap just to be sure they are ok. Then if i still cant get the car to run smooth, ill be contemplating the weber.
Thanks for your help, ill keep your number handy.
Regards,
Steve.
Posted: Thu Jan 25, 2007 4:47 pm
by Mitch
I had a similar problem on a morris minor and it was down to a gap between the carb and manifold causing an air leak. I fitted new gasket and it was fine. But i do agree with Ray though, i swapped my carb for a weber and it is far better.