question about nuts and bolts.

t148ljn · Post by **t148ljn** » Sun Nov 05, 2006 8:00 pm

Can anyone out there advise me as to which imperial thread type was used on the series 1 humber sceptre as i need to purchase loads of nuts and bolts to assemble the car which I recently aquired. sorry to keep asking all these questions but I dont know who else to ask. Regards Paul.

robbo · Post by **robbo** » Thu Nov 09, 2006 9:26 pm

Phone Speedy Spares there quite helpful.

RAYREES · Post by **RAYREES** » Thu Nov 09, 2006 9:29 pm

HI PAUL,

THE THREAD USED ON YOUR SCEPTRE ARE U.N.F ,ALL ARE OBTAINABLE

BUT SOME COMPONENTS ON YOUR CAR HAVE 7/16 U.N.F NOT MANY

PEOPLE STOCK THIS , BUT IF YOU HAVE ANY PROBLEMS GETTING

HOLD OF ANY GIVE ME A RING AND I WILL SEND YOU SOME DOWN

ALL THE BEST

RAY

t148ljn · Post by **t148ljn** » Fri Dec 01, 2006 7:22 pm

many thanks for taking time to reply it really is appreciated. just wondering if you would know which way round the rubber seals on the master cylinder ( brake) face or where I could purchase a haynes manual for a series 1 humber sceptre. once again thankyou. Regards Paul.

Post by **Dave** » Sat Mar 10, 2007 12:08 pm

For a rough drawing click on 'Plate A' of :-
http://www.rootes1725cc.co.uk/sceptre/partlist/q/q.htm

Rootes1725cc

question about nuts and bolts.

question about nuts and bolts.

NUT & BOLTS THREADS

Master cylinder seals