Super Minx Estate Project

Post Reply
thowman
Posts: 79
Joined: Mon May 24, 2010 9:31 pm

Super Minx Estate Project

Post by thowman » Mon Oct 03, 2011 9:49 am

Introducing my Super Minx Estate. I bought this car off ebay at the end of July, mainly due to it being a LHD car. I will be moving to Spain next year, and need a suitable car - and this appeared. As it's been registered in the UK from new and has no record on the V5 as being an import, I can only assume that the car was owned by a serviceman based in Germany - apparently quite common for them to buy LHD cars in the UK. It's finished in a non original blue, being orginally supplied in Azure Blue, code 57. It will be returned to this.

I collected the car from Whites of Coventry, a vehicle breakers that are just over the road from the former factory site in Ryton. The guy that helped me load it up onto the trailer told me that several banger racers wanted the car, but they wanted to try to sell it to someone to restore.

Image

Image


The good news is that the underneath is very solid. The previous owner, there being just one, seems to be one of these guys that used to spray old engine oil on the underside. Hiding beneath this is pristine metal. However, the sills are completely shot. It was listed as having new front wings and sills, but the sills were just aluminium pop rivited cover sills. Not nice. It's a shame, as it's really the only structural rust the car has.

Image

Image

Image

Image

Image

Image

Image

Image

I removed the engine and auto box last week. The engine is a non runner, and not the original. I believe it's from a Arrows Minx - but at this moment i am unsure what the capacity is. The bores are well worn, and I have a replacement block all ready to go in that is in excellent condition - and is a 1725 unit. So, the engine will be weighed in. Ideally, as the car will be used for touring and attending events in Spain and the UK, I will be looking to convert it to an Manual with overdrive. I have the box and overdrive already, but need a pedal box and clutch slave and master cylinder. I assume that the pedal box is the same, regardless of side?

Also need to source new bumpers, a tow bar, a replacement set of rims, clutch components, od gearbox mount, shorter propshaft and front grille.

What replacement panels are available off the shelf? Who supplies them....

It has rear seat belts fitted, presumably added at the time of building as it has the Irving alloy clasps on it and Rootes stickers on the belts themselves. As the car will be used to transport the kids in the back, I am going to have to replace these with modern 3 point ones (otherwise the other half won't let the kids in it) so I will be selling these on at some point as I know they are quite valuable and sought after.
Image

Will also be looking into fitting air conditioning as Spain in summer without it in a car is not a nice experience. Plenty of room under the dash for locating it.

The rebuild will be taking place over the winter, and I will keep the thread up to date with the progress.

sceptictank
Posts: 77
Joined: Fri Jun 03, 2011 4:28 pm

Re: Super Minx Estate Project

Post by sceptictank » Mon Oct 03, 2011 1:32 pm

Doesn't look too bad above sill level, but a little 'crusty' underneath - but then, aren't they all!

Good luck with the resto, and it's good to hear that it's been saved from the' banger boys'

Look forward to seeing the updates. :)

Post Reply