Unhappy starter

Post Reply
big_steve
Posts: 76
Joined: Sun Jan 21, 2007 9:12 pm
Location: Suffolk

Unhappy starter

Post by big_steve » Tue Jan 23, 2007 7:53 pm

I have the 1725cc engine with a twin choke Solex carb. It hates starting from cold and is actually harder to start with the choke. Once ive got it running i have to sit in the car holding the revs at 1500 - 2000 until the engine warms enough to tick over. Its very lumpy until it warms to full temperature. Then the tickover sits at 1500rpm. I have tried to adjust the slow running in accordance to the handbook but a (fairly) smooth tickover when warm means a pig to start when cold. Cap, condenser and points are new. Plugs are set correctly. Car is very thirsty, could this be worn jets? If so, where can i source a set? (She runs perfectly when warm, its just the tickover is high)
Any ideas??? Cheers.
What did cured ham actually have?

RAYREES
Posts: 46
Joined: Tue Aug 29, 2006 9:03 pm

CARB TROUBLE

Post by RAYREES » Wed Jan 24, 2007 9:18 pm

HI BIG STEVE ,THE PROBLEM LIES IN YOUR CARB ,PUT IT IN THE BIN AND FIT A WEBBER CARB ,THE ONE YOU HAVE FITTED TO YOUR CAR WERE NEVER ANY GOOD EVEN WHEN THEY WAS NEW.
IF YOU REQUIRE A CARB CONVERSION FOR YOUR CAR PLEASE GIVE ME A RING AS I AM SURE WE HAVE A COUPLE LEFT.

ALL THE BEST RAY

TEL 07932 339503

big_steve
Posts: 76
Joined: Sun Jan 21, 2007 9:12 pm
Location: Suffolk

Post by big_steve » Wed Jan 24, 2007 11:40 pm

Hi Ray.
Is there nothing i can do with the original carb at all? If i have to get a Weber then so be it, but id like to keep the engine original if possible. I noticed today that she runs better without the air filter, but the filter itself is clean and fairly new. Tomorrow im going to re-check the timing and re-check the points gap just to be sure they are ok. Then if i still cant get the car to run smooth, ill be contemplating the weber.
Thanks for your help, ill keep your number handy.
Regards,
Steve.
What did cured ham actually have?

Mitch
Posts: 15
Joined: Mon Jan 08, 2007 7:49 pm
Location: essex
Contact:

Post by Mitch » Thu Jan 25, 2007 4:47 pm

I had a similar problem on a morris minor and it was down to a gap between the carb and manifold causing an air leak. I fitted new gasket and it was fine. But i do agree with Ray though, i swapped my carb for a weber and it is far better.

Post Reply