engine identity
-
snowy
- Posts: 2
- Joined: Thu Sep 05, 2013 8:57 pm
engine identity
Hi. I recently bought an engine supposedly taken from a 1966 minx series vi. the vendor didn't know what size the engine was. as this model used the 1725 how can I establish whether this is a 1725? this is an iron head engine. the engine markings I found on the block are 1980 854 14-8-62 and on the head. H3 SC C22155. the carb is a Zenith VN. any ideas guys? Thanks. Snowy
-
thowman
- Posts: 79
- Joined: Mon May 24, 2010 9:31 pm
Re: engine identity
quickest was is to look to see if it is a 5 bearing engine or not. Look for where the oil pressure switch is, and count the number of drillings of a similar nature that are in the bottom of the block, below the oil filter and distributor. a 1725 engine will have 5 holes, that have plugs in them - or things like oil pressure switch, smaller engines will have only 3 bearings, and therefore 3 drillings.
It's also worth looking at the engine number. All rootes cars "should" have the same engine number as chassis number if they still have the original engine. Failing that, the engine number should reveal what it was orginally from. A humber sceptre Mk1 will begin with B310, which is a 1600 engine, and a Mk2 with the 1725 starts with B312. If there is no engine number stamped in the block, next to the oil filter housing, then it's probably an exchange engine, and so you'd need to look at the bearings. The only engine I am not sure of is the 1500 hunter engine.
Failing that, you would need to dismantle the engine and measure the conrod length, which varies for engine size - the bore always being the same regardless of size.
It's also worth looking at the engine number. All rootes cars "should" have the same engine number as chassis number if they still have the original engine. Failing that, the engine number should reveal what it was orginally from. A humber sceptre Mk1 will begin with B310, which is a 1600 engine, and a Mk2 with the 1725 starts with B312. If there is no engine number stamped in the block, next to the oil filter housing, then it's probably an exchange engine, and so you'd need to look at the bearings. The only engine I am not sure of is the 1500 hunter engine.
Failing that, you would need to dismantle the engine and measure the conrod length, which varies for engine size - the bore always being the same regardless of size.
-
snowy
- Posts: 2
- Joined: Thu Sep 05, 2013 8:57 pm
Re: engine identity
Thank you Thowman...i'll check those things out. as the vendor had scrapped the car some while before and had no clue as to the engine size..all he knew was that it was a 1966 Minx.