timing degree

Post Reply
timmo478
Posts: 47
Joined: Sat Nov 16, 2013 5:19 pm

timing degree

Post by timmo478 » Sun Nov 24, 2013 6:58 pm

Hi all, I'm about to convert to electronic ignition distributor and want to know what the best timing degree would be. My cylinder head has been changed to run on unleaded so didn't know whether to trust what the books say as they would surely be figures for leaded fuel.
I'm also on ngk plugs and a Lucas sports coil.
Many thanks..........
ImageThe Black Mafia

rhythmrider
Posts: 89
Joined: Mon Sep 02, 2013 6:58 pm

Re: timing degree

Post by rhythmrider » Thu Nov 28, 2013 6:19 pm

There are a lot of variables to consider.
I am assuming that you mean the initial timing advance that you set at idle.

Does your new distributor have electronic or mechanical advance?
Does it have programmable advance curves and variable dwell?
Does your car still need to meet any emissions requirements?

If your answer is "mechanical" for the first question and no for the last two, then setup is pretty simple.
You can set the advance for best performance. (this is assuming that your carburetor is already perfectly and properly setup)

I would forget any book and set initial advance using the "old school" method.

1. Make sure your car is completely warmed up and it's not a cold day.
2. Set initial advance to about 5 degrees.
3. Rev the engine quickly a few times (like a teenage boy at a stoplight). Any pings? no?
4. Set to 10 degrees, rev a few times, any pings? if so, roll it back until there are no pings on reving it up.
5. Go drive the car under load (fastest acceleration the car can do and also find a hill to drive up as fast as possible. And pings?
6. Find the point of ping and roll it back about 2-3 degrees.

The biggest danger to exhaust valves is not too much advance, but excess heat from retarded advance settings.
Having your ignition too advanced could cause damage to you pistons, piston pins, connecting rods, and bearings.

Or you can spend a few $$$ and go to a dyno shop and have them set it for you.

That is my "2 cents"
You can take it for what it is worth! :D

Post Reply