Thanks!
Brake failure.
-
oddbal
- Posts: 6
- Joined: Mon Oct 07, 2013 6:22 pm
Brake failure.
Hello all! My brake master cylinder is leaking. Its leaking from the actual reservoir that hold the fluid in the engine bay. It must have rusted through.
Where can I find a replacement? Or do you have a spare one I could buy?
Thanks!
Thanks!
-
nzchevy
- Posts: 22
- Joined: Sun Aug 25, 2013 5:05 pm
Re: Brake failure.
Have you tried Powertrack :-
http://www.powertrackbrakes.co.uk/wcyli ... l#cylinder
or Howard at Collectors Car Parts :-
http://www.collectorscarparts-heathrow. ... ction/3/6/
Regards
Roger
http://www.powertrackbrakes.co.uk/wcyli ... l#cylinder
or Howard at Collectors Car Parts :-
http://www.collectorscarparts-heathrow. ... ction/3/6/
Regards
Roger
-
rhythmrider
- Posts: 89
- Joined: Mon Sep 02, 2013 6:58 pm
Re: Brake failure.
If your master cylinder is ok with the exception of the "can" rusting though, you can actually just solder it up.
Any "old school" radiator shop should be able to do it. It looks like a "tin can" and it is!
But if it has rusted through, check to see if it was from the inside or outside.
I only say this because if you are not using silicone based break fluid, the non-silicone brake fluids attract water, so you might have some water inside of your break lines.
This could end up rusting out your brake lines as well...
Any "old school" radiator shop should be able to do it. It looks like a "tin can" and it is!
But if it has rusted through, check to see if it was from the inside or outside.
I only say this because if you are not using silicone based break fluid, the non-silicone brake fluids attract water, so you might have some water inside of your break lines.
This could end up rusting out your brake lines as well...