sunbeam ser 5 starting/running problems

Post Reply
haystack
Posts: 1
Joined: Fri Jun 03, 2011 9:37 pm

sunbeam ser 5 starting/running problems

Post by haystack » Fri Jun 03, 2011 9:54 pm

i need help with my ser 5. its very hard to start.usually the battery will appear to have run down after a few attempts only to then come back to life strong as ever. its like as if it takes time for the charge to buil up again. after i turn off the key the car will often continue to run for a few seconds . the car is also running badly a little spluttery with backfires , lack of power ect. the sparkplugs are ok i think. i suppose that the points are off also.

what i had in mind is instal an electronic ignition system. can anyone recommend a make and model and where id source it?

do i need a new coil and would it solve the problem at starting the engine ? what coil should i buy and where would be a good place to source one


all help appreciated !

teddy tyres
Posts: 4
Joined: Sat Sep 10, 2011 2:16 pm

Re: sunbeam ser 5 starting/running problems

Post by teddy tyres » Sat Sep 10, 2011 2:21 pm

I now this is a bit late now but did you get the information that you needed if not then you can email me at t.tyres@ntlworld.com hopefully should be able to help you

husky
Posts: 3
Joined: Tue Aug 16, 2011 10:47 am

Re: sunbeam ser 5 starting/running problems

Post by husky » Tue Sep 13, 2011 11:58 am

From 33 years experience in the repair business, I would say the starter motor is at fault for the slow cranking speed assuming your battery is good and charged but get it checked as I am merely guessing from what you have writtn, the rough ruining could be any number of items, probably best to find a reliable mechanic/ garage (classic friendly) . As from experience trying to diagnose faults via email is costly and time consuming, as your problem could be fuel, ignition, mechanical or a combination of all three.

MIKEFLBMER
Posts: 4
Joined: Tue Dec 25, 2012 1:28 am

Re: sunbeam ser 5 starting/running problems

Post by MIKEFLBMER » Tue Dec 25, 2012 2:38 am

Check for weak or corroded ground on Battery....Poor ground can cause these problems...as fo ignition...try accuspark....sold on ebya UK

sahir11
Posts: 1
Joined: Mon Feb 03, 2014 12:38 pm

Re: sunbeam ser 5 starting/running problems

Post by sahir11 » Mon Feb 03, 2014 12:40 pm

Over here in the UK there are specialist welders who can 'stitch weld' a crack in the engine block and bring it back to life again. Not sure whether you have that facility over the pond, but I would have thought so. Saves looking for a replacement engine/block then.
sahir

Post Reply